Boring a door for a lock the right way, this complete lock installation kit gives a tradesperson or homeowner the carbide hole saws and the self-centering jig needed to cut a wood door for a knob, lever, or deadbolt from scratch -- no separate bits or paper templates to buy or line up. The jig clamps to the door and locks the hole saw on center at the chosen backset, so the large face bore and the smaller edge latch bore come out the correct size and in true alignment, letting the latch meet the lock and the door work smoothly. Carbide teeth cut fast and clean and hold their edge far longer than steel. It is a time-saver that turns a tricky freehand job into a few confident cuts.
Key Features:
- Complete Door-Boring Kit -- Includes the carbide hole saws and the alignment jig needed to bore a wood door for a knob, lever, or deadbolt -- no separate bits or templates required.
- Cuts Both Bores Correctly -- Bores the large face hole for the lock body and the smaller edge hole for the latch at the right diameters and in true alignment, so the latch meets the lock and the door closes smoothly.
- Self-Centering Jig -- Clamps to the door and holds the hole saw on center at the chosen backset, preventing the off-center, angled, or blown-out holes that ruin a door when boring freehand.
- Fits Common Doors & Backsets -- Adjusts for standard interior and exterior door thicknesses and both the 2-3/8" and 2-3/4" backsets used on residential and commercial locks.
- Carbide-Tipped for Clean Holes -- Carbide teeth cut fast through wood and composite doors, resist dulling, and leave a smooth bore with minimal tear-out.
Where to Use:
- Lock installation -- Boring a new wood door for a lock.
- New locks & upgrades -- Fitting entry, privacy, passage, and deadbolt locks.
- Repair & rehang -- Re-boring or enlarging for a replacement lock.