TRAP - RB LOW SEAL 1-1/2"

Sealing out sewer gas under a sink, this 1-1/2" P-trap is the curved drain fitting that holds a water seal in its U-bend to block sewer odors from rising through the drain while wastewater flows to the drain line. Made of rough (unplated) brass, it connects the sink tailpiece to the drain arm with slip-joint nuts and washers for a serviceable joint. Rough unplated brass is made for concealed, behind-wall and below-floor installs where a finished surface is not seen, giving a rugged, code-grade trap. A low-seal design uses a shallower bend to fit tight spaces under a sink where a standard trap will not. Sized 1-1/2" for a sink drain, it is a direct-fit replacement for a corroded, leaking, or clogged trap and an essential fitting for a sink drain install.

Key Features:

• Blocks Sewer Gas -- Holds a water seal in the U-bend to block sewer odors from the drain.
• 1-1/2" Size -- Sized 1-1/2" for a sink drain connection.
• Rough Brass -- Rough unplated brass is made for concealed, behind-wall and below-floor installs where a finished surface is not seen, giving a rugged, code-grade trap.
• Low-Seal Design -- A shallower bend fits tight spaces under a sink.
• Slip-Joint Connection -- Joins the tailpiece to the drain arm with serviceable slip nuts and washers.

Where to Use:

• Sink drainage -- Trapping a kitchen, bath, or utility sink drain.
• Drain repair -- Replacing a corroded, leaking, or clogged trap.
• Plumbing install -- An essential fitting for a sink drain.